Vehicle Installation Record Form
Installer Form
Items you will need
1. One Fleetsu Tracker Device
2. One Y-Cable
3. One USB Standard consumer battery or wall-mounted phone charger.
4. One Micro USB Cable [ Image ]
Installation Instructions
(Before removing panelling). Plug GX2 device into USB charger with cable to allow it to power on and sit for a minimum of 5 minutes to receive any new updates. | |
1. Remove panelling from vehicle to achieve access to OBD plug and fit Y Cable. | |
2. Locate OBD plug on vehicle | |
3. Remove plug from the panel | |
4. Plug-in Y cable and secure with cable tie | |
5. Insert Y cable OBD plug back into the panel |
6. Plug GPS unit into Y cable and secure with a cable tie |  |
7. Locate a suitable firm mounting location. Must be rigid. (e.g. chassis or framing bracket) | |
8. Ensure GPS unit sticker is facing outwards (not on framing bracket) |
9. Mount GPS unit firmly with cable a minimum of 3 X Cable ties. On both vertical and horizontal axis. Note – Cable ties to be applied both vertically and horizontally. |  |
10. Test to make sure device will not wiggle or move | |
11. Ensure indicator lights on unit are flashing | |
12. Leave vehicle running and idle for at least 4 minutes, check there are no warning lights on the vehicle | |
| 12. Re-assemble any removed panels |
13. Affix two QR code stickers to the vehicles as per following details: | |
a: 2.5cm X 7.5cm for driver upper right side of windscreen – Inward |  |
| b: 3.5cm X 10cm for near the door handle outside of the vehicle (drivers side)” |  |